BD Logic Guía para resolver problemas descargar pdf (Pagina 27)

44 • How to Use Your Monitor’s Optional Memory Functions

How to Use Your Monitor’s Optional Memory Functions •

A blood glucose test can be marked after completing a test. For an

explanation of situations in which you may wish to mark a blood

glucose test, refer to page 36.

1. Test your blood glucose. (Refer to page

21 for how to test.)

2. After a blood drop is applied to the

test strip, the display counts down from

5 seconds and shows your test result.

3. To mark your test result, press the

right or left arrow button. An

asterisk (

) appears, to confirm that the

test result is marked. To unmark the test

result, press the right or left

arrow button until the asterisk

disappears.

Marked Blood

Glucose Test Result

(Example)

Marking a Blood

Glucose Test

mmol/L

Blood Glucose

Test Result

(Example)

5. Press the right arrow button

to enter your insulin units. Use the

right or left arrow buttons

to adjust units up or down.

6. To save the insulin dose, press the

Mode button briefly, or press the

Insulin Recording button. A long

beep sounds to confirm that the insulin

dose was saved. (Refer to page 46 for

marking your insulin dose.)

7. If you inject more than one type of

insulin at one time, turn off the monitor

by pressing and holding the Mode

button. Repeat steps 2 through 6

to record your next insulin type.

8. You have finished recording your insulin

information. To turn off your monitor,

press and hold the Mode button

until the monitor turns off, OR the

monitor will turn off automatically

after 1 minute.

NOTE:

It is recommended that you record your insulin within

10 minutes after injecting to make sure it is recorded with the correct

date and time.

(Continued on next page.)

Select

Insulin Dose

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 37 38

Comentarios a estos manuales

Sin comentarios

BD Logic Guía para resolver problemas Pagina 27

Comentarios a estos manuales